Hooded Fleece Pullover with Crackle Pattern and Front Pocket Flap

Ningbo Haishu Dongbang Garment Co., Ltd. in China develops the Hooded Fleece Pullover with Crackle Pattern and Front Pocket Flap around a broad horizontal front detail. The flap cuts across the irregular pattern, while the short center zip and lower side openings introduce vertical lines.

Images illustrate the reference style. The specifications describe a proposed production version and can be adjusted during development.

Product Details

The Hooded Fleece Pullover with Crackle Pattern and Front Pocket Flap gives the lower front more structure than a plain hooded layer. A broad flap crosses the body below the short zip, while separate zipped entries sit farther down at the sides.

The proposed arrangement uses a front flap pocket and lower hand pockets. Their compartments need a physical sample review so access, usable depth and pocket-bag attachment are resolved behind the patterned surface.

Crackle Print on Fleece

The Hooded Fleece Pullover with Crackle Pattern and Front Pocket Flap uses 100% polyester microfleece at 280 GSM. The selected print route is sublimation, with a material trial to review pattern clarity and the napped surface after heat exposure.

The crackle repeat has lighter dense areas and quieter dark areas. Cutting should keep that balance visible across the body and sleeves without treating every seam as an exact pattern match.

Open Hem and Pocket Access

The hem stays open, so the lower pocket bags should sit inside without pulling it inward. A simpler front without the flap pocket is a development option; it would leave a larger uninterrupted print area and needs a revised front pattern.

Suggested Development Specifications

Development Size Guide (cm)

Suggested garment measurements. Values labelled 1/2 arelaid-flat half widths, not full circumferences.

Body length: high shoulder point to hem, excluding hood or collar. Chest: half width at underarm level, laid flat without stretching. Sleeve length: shoulder seam to sleeve edge; measured from the dropped seam where applicable.

Checking Concealed Pocket Construction

Dongbang’s pattern and sample teams can develop pocket structures from a sketch, reference garment or technical pack. For this pullover, the sample should make the relationship between the flap and lower pockets clear before production.

First-piece approval can establish pocket access, reinforcement and internal bag attachment. Finished-garment checks can compare those details with the approved patterned fleece reference.

Our Certificates

FAQ

1. Are the flap and lower zip openings one pocket?

The proposed version treats them as separate storage areas. Their internal layout must be confirmed on the development sample.

2. How do the pocket bags affect the open hem?

Their weight and attachment should be checked on the sample. They need to sit inside the body without drawing the lower edge inward or hanging below it.

3. Must the crackle marks align at every seam?

The base uses an all-over repeat with a coherent distribution. Exact seam matching is an additional requirement to review with the cutting layout.

4. What is the MOQ for this style?

Our standard MOQ starts from 500 pieces per style. The final requirement depends on colors, sizes, fabric, trims and construction. Lower quantities may be possible for some products with adjusted pricing; color and size allocations are discussed for the order.

5. Will we approve a sample before bulk production?

Yes. The project may use development, fit, size-set and other samples as required. The pre-production sample must be approved before bulk production, confirming the fit, materials, colors and workmanship.

Confirm the Pocket Layout

Send an internal pocket sketch and the preferred crackle repeat for the Hooded Fleece Pullover with Crackle Pattern and Front Pocket Flap (DB0052). Mark the intended contents and opening sizes so the front construction can be sampled.